Installation Guide

DISCLAIMER:
Installations of this kit could be subject to national and local building and electrical codes. Installers should have adequate knowledge of
national and local code to ensure the installation passes inspection by the local electric authority.
Proper fuses or breakers should be used to comply with all local and national codes. Contact Grape Solar for specific recommendations.
All batteries used for this system should be identical. Do not mix battery types or sizes. Do not mix old batteries with new batteries.
Performance and charging anomalies can occur if types, sizes, or age of batteries are not identical.
Grape Solar does not warrant the accuracy, sufficiency, or suitability to all customers of any technical or other information provided in
product manuals. Grape Solar does not claim any responsibility or liability for losses, damages, costs or other expenses whether special,
indirect, consequential or incidental, which might arise out of the use of such information.
1
200 Watt Off-Grid Expansion Kit
(GS-200-EXP)
Quick Connect Guide
IMPORTANT: Please read GS-STAR-200W connection guide
(included with product) before assembling kit.
For additional information about Grape Solar products:
email [e-mail], or
call 1-877-264-1014 for live telephone support.
Check your order to make sure that all parts are included:
 20-amp In-line MC4 Fuse
 MC4 Branch Connector Set
 2x 16-Inch MC4 Cables
 GS-STAR-200W Solar Panel
GS-200-EXP PHOTOVOLTAIC
POWER GENERATION SYSTEM
QUICK CONNECT GUIDE Rev. 200722


2
3

www.GrapeSolar.com
Tel. [phone] (toll free), 1-541-349-9000
Document Version 200722
©Copyright 2019, Grape Solar, Inc. All Rights Reserved
Mount the additional solar panel  so that it is facing due South at approximately the same angle as your lati-
tude. The ideal area has full sun and no shading. If the following connections are made during daylight, cover all
panels with cardboard, cloth, or a similar opaque material so that the panels do not output power.
Connect the In-line MC4 Fuse  to the positive lead
of the new solar panel . Disconnect the MC4 con-
nections of the original panel, and insert a Branch
Connecter  into each of the resulting gaps. Use
the 16-inch MC4 cables  to connect the new solar
panel  to the Branch Connectors .

x2
[diagrams not to scale]





[original panel]