Instructions / Assembly

ManualsBrandsGrape Solar ManualsElectrical200-Watt Off-Grid Solar Panel Kit

Grape Solar 200 Watt Off Grid Kit (GS-200-KIT)

Installation Guide

IMPORTANT: Please read the Panel User Guide, charge controller and inverter manuals

before connecting the kit components

REQUIRED TOOLS: wire cutter/stripper, phillips head screwdriver

www.grapesolar.com

Tel. 1-877-264-1014 (toll free), 1-541-349-9000, Fax: 1-541-343-9000

For additional information about this kit visit grapesolar.com/manuals.html, or email support@grapesolar.com

GS-200-KIT EXPANDABLE PHOTOVOLTAIC

POWER GENERATION SYSTEM

CONFIGURATION MANUAL Rev. 180601

Valid from June 2018

Basic Wiring Diagram

Summary of content (4 pages)

PAGE 1
GS-200-KIT EXPANDABLE PHOTOVOLTAIC POWER GENERATION SYSTEM CONFIGURATION MANUAL Rev. 180601 Grape Solar 200 Watt Off Grid Kit (GS-200-KIT) Installation Guide IMPORTANT: Please read the Panel User Guide, charge controller and inverter manuals before connecting the kit components REQUIRED TOOLS: wire cutter/stripper, phillips head screwdriver Basic Wiring Diagram For additional information about this kit visit grapesolar.com/manuals.html, or email support@grapesolar.com ©Copyright 2016, Grape Solar, Inc.
PAGE 2
GS-200-KIT EXPANDABLE PHOTOVOLTAIC POWER GENERATION SYSTEM CONFIGURATION MANUAL Rev. 180601 QuickStart Setup Step 1: Check your order to make sure that all parts are included.
PAGE 3
GS-200-KIT EXPANDABLE PHOTOVOLTAIC POWER GENERATION SYSTEM CONFIGURATION MANUAL Rev. 180601 QuickStart Setup If your battery has sufficient charge (11.5 volts or more), you should now see the LCD display on the controller activate. This means the controller has power (controllers are powered by the battery, not the panels). Step 6: Connect the inline fuses to the positive cable outputs of each panel. Then connect the positive and negative outputs of both panels to the appropriate T-branch connector.
PAGE 4
GS-200-KIT EXPANDABLE PHOTOVOLTAIC POWER GENERATION SYSTEM CONFIGURATION MANUAL Rev. 180601 QuickStart Setup Step 8: Connect the bare wire end of the positive cable to the “PV Positive” input of the controller, and the negative cable end to the other ‘PV Negative” input (the terminals on the left side). Step 9: Connect the second red (positive) and black (negative) 5-foot cable from battery to inverter. Step 10: Uncover the panel.