Installation Guide

EZ Metal Roof Mount

Attachments

10 of 12

Installation Instructions:

EZ Metal Roof Mount Kit K20051-XXX

1. From the marked location drill the pilot hole for the Lag

Bolt with a 7/32” drill bit. For maximum strength, the hole

should not be more than 3” in depth, and a drill stop may

be used to insure this.

2. To ensure a strong and water tight seal, wipe away

excess grease or debris from the mounting location. Fill

pilot hole with sealant, such as ChemLink DuraLink for

metal roofs. Install AL Shoe to Metal Roof by using 5/16”

Lag Bolt. Tighten to 25 ft. lbs. torque.

3. Install L-Foot to AL Shoe and lightly hand tighten Hex

Cap.

4. Install AL Rail to L-Foot to the specific orientation. Then,

tighten 3/8” Flange Nut to 15 ft-lbs. and Hex Cap to 15 ft-

lbs. torque.