Full Product Manual

EZ Pitched Roof System

22 of 30

Optional Mounting Instructions:

EZ Roof Mount Kit K10068-B20

1. From the desired location, move down the roof 2-1/4”

from the bottom of the shingle, and locate the EZ Roof

Mount AL Shoe center. The AL Shoe will be used as a

template to locate the 4 screws.

2. Place a bead of Chem-link M1 for wood and composite

roofs along the length of the screw four (4) 1/4” X 3” self-

drilling Decking Screws. Mount the AL Shoe to the roof

through the shingles using the four Decking Screws. The

screws will penetrate the roof sheathing and should

protrude through the sheathing at least 1/2”. Maximum

pullout strength requires that the threads extend below

the sheathing.

3. Make sure the Sealing Washer is positioned correctly on

the threaded shank of the AL Shoe. Use roofer bar to lift

roof shingle, slide the flashing under shingle, and insert

the Flashing on threaded shank as shown. For additional

waterproofing apply beads of sealant as shown.

4. Insert L-Foot to AL Shoe on top of Flashing. Place AL

Hex Cap on Shoe, and lightly hand tighten Hex Cap.

5. Install AL Rail to L-Foot to the specific orientation. Then,

tighten 3/8” Flange Nut to 15 ft-lbs. and Hex Cap to 15 ft-

lbs. torque.

Warning: The self-drilling decking screw mount option is

only suitable for roofs less than 5/12 pitch and should only

be used with a direct L-Foot attachment.

Avertissement: L'option de montage à vis à plate-forme auto-

perçage ne convient que pour des toits de moins de 5/12 et ne

doit être utilisée qu'avec une fixation L-Foot directe.

2-1/4”