Instructions / Assembly

6
GS-400-KIT PHOTOVOLTAIC
POWER GENERATION SYSTEM
QUICK CONNECT GUIDE Rev. 210518
www.GrapeSolar.com
Tel. [phone] (toll free), 1-541-349-9000
Document Version 210518
©Copyright 2021, Grape Solar, Inc.
Connect the positive solar panel cables  to the “female” fuse ends  from the previous connections. Connect
the negative panel cables  to the “male” parallel connector ends  of the other MC4 parallel cable.
Notice that for each MC4 parallel connector , the two outer parallel cables are longer than the two inner parallel
cables. Reserve the longer cables for the solar panels  that are further from the MC4 parallel connector “hub”.
Use the two 15-ft. MC4 cables  to connect the Parallel Cable Pair  to the Comet-40 charge controller .
Remove the panel covering. In good sunlight, the charge controller’s  ”BAT %” should increase to 100%. When
the controller is set to “LOAD ON,” the system will provide power through the load control output or through the
USB port.
7
8





4 x 1 configuration 2 x 2 configuration









  




*12V deep cycle battery is not included with kit