Instructions / Assembly

6
GS-400-KIT PHOTOVOLTAIC
POWER GENERATION SYSTEM
QUICK CONNECT GUIDE Rev. 190316
www.GrapeSolar.com
Tel. [phone] (toll free), 1-541-349-9000
Document Version 20190316
©Copyright 2019, Grape Solar, Inc. All Rights Reserved
Connect the positive panel cables  to the “female” fuse ends  from the previous connections. Connect the
negative panel cables  to the “male” parallel connector ends  of the other MC4 parallel cable.
Notice that for each MC4 parallel connector , the two outer parallel cables are longer than the two inner parallel
cables. Reserve the longer cables for the solar panels  that are further from the MC4 parallel connector “hub.”
Use the two 15-ft. MC4 cables  to connect the Parallel Cable Pair  to the MC4 Charge Controller cables .
Remove the panel covering. In good sunlight, the
charge controller’s  ”BAT %” should increase to
100%. When the controller is set to “LOAD ON,”
the system will provide power through the load
control output or through the USB port.
7
8





4 x 1 panel configuration
2 x 2 panel
configuration





