Full Product Manual

EZ Pitched Roof System
4 of 30
Installer Responsibility:
Before ordering and installing materials, all system layout dimensions should be confirmed by field measurements. SunModo
reserves the right to alter, without notice, any details, proposals or plans. Any inquiries that you may have concerning installation
of the PV system should be directed to your SunModo Sales representative. Consult SunModo Sales for any information not
contained in this manual. This manual is intended to be used as a guide when installing SunModo’s EZ Roof Mount System on
pitched roofs. It is the responsibility of the installer to ensure the safe installation of this product as outline herein.
 Installer shall employ only SunModo products detail herein. The use of non SunModo components can
void the warranty and cancel the letters of UL compliance.
 Installer shall guarantee that screws and anchors have adequate pullout strength and shear capacities.
 Installer shall adhere to the torque values specified in this Instruction Manual.
 Installer shall use anti-seize compound, such as Permatex anti-seize, lubricant is recommended for all
threaded parts.
 Installer is responsible to install solar panels over a Fire Resistant roof covering rated for the application.
 Installer is responsible to determine that the roof, its rafters, connections, and other architectural support
components can sustain the array under all code level loading conditions.
 Installer shall adhere to all relevant local or national building codes. This takes account of those that
supplant this document’s requirements.
 Installer shall guarantee the safe placement of all electrical details of the PV array.
 Installer shall comply with all applicable local, state and national building codes, including periodic re-
inspection of the installation for loose components, loose fasteners and any corrosion, such that if found,
the affected components are to be immediately replaced.
 Installer to ensure the structural support members or footings for mounting the array can withstand all
code loading conditions. Consult with licensed professional engineer for the appropriate loading
conditions.
 Installer to follow all regional safety requirements during installation.
 This racking system may be used to ground and/or mount a PV module complying with UL 1703 only
when the specific module has been evaluated for grounding and/or mounting in compliance with the
included instructions.
 Installer shall ensure bare copper grounding wire does not contact aluminum and zinc-plated steel
components to prevent risk of galvanic corrosion.
 If loose components or loose fasteners are found during periodic inspection, re-tighten immediately. If
corrosion is found, replace affected components immediately.
Safety:
Review relevant OSHA and other safety standards before following these instructions. The installation of solar PV systems is a
dangerous procedure and should be supervised by trained and experienced personnel.
It is not possible for SunModo to be aware of all the possible job site situations that could cause an unsafe condition to exist.
The installer of the roof system is responsible for reading these instructions and determining the safest way to install the roof
system. These instructions are provided only as a guide to show a knowledgeable, trained erector the correct part placement
one to another. If following any of the installation steps would endanger a worker, the erector should stop work and decide upon
a corrective action. Provide required safety railing, netting, or safety lines for crew members working on the roof.
Specifications:
EZ Roof Mount K10068 is certified for International Building Code and International Residential Codes (IRC) by IAPMO.
Evaluation Report is 0248, structural test per EC002-2011 and rain test per UL 441-96.