Installation Guide

6
7
Install the Ghost Pickups using the instructions in the Ghost Pickup System user
manual, pages 4-6. The manual is included with the GHOST Saddle Pickups, or
the GHOST Acousti-Phonic Pre-amp. Follow the instructions for your particular
instrument.
Do not connect the pickups to the common connector block. This is not needed
when using the Hexpander. Instead, each pickup will be connected individually
to the Hexpander.
•
•
STEP 1: Installing the GHOST Pickups.
READ THOROUGHLY BEFORE INSTALLING.
See tips on Page 21.
Diagram 1.
BLACK (E), BLUE (B), GREEN (G), YELLOW (D), RED (A) & WHITE (E) LEADS.
If you plan on installing the Hexpander close to the GHOST Saddle Pickups you
will be able to plug the pickups directly in to the Hexpander.
If you plan on installing the Hexpander further away from the GHOST Saddle
Pickups, the wires may not reach. In this case plug the wires from the pickups
into the Extension Connector (BE-0513-00, Diagram 1). Plug the Extension
Harness (BE-0511-00) into the other side of the extension connector. Secure
the extension connector in place with the double -sided foam tape supplied.
• The wire from the pickups should be connected to the connector block in
order, as shown. The wire from the pickup on String 1 (High E) aligns with the
blue tracer wire in the extension cable.
Extension
Connector
(BE-0513-00)
Extension
Harness
(BE-0511-00)
Blue Tracer
Wire
String 1
(High E)
String 6
(Low E)
B
G
D
A