User Manual
38
Converting the joysticks
1. Loosen the four screws holding each of the two
joysticks
2. Then disconnect the 7 pin plug connector from the
joysticks to the circuit boards.
3. The joystick circuit boards can now be exchanged.
4. Reconnect each of the 7 pin plugs to the circuit
board
5. Reassembly is done in reverse order
Ensure that the axis of the joystick circuit board is proper-
ly positioned in the base.
Important notices:
When closing the transmitter housing, ensure that …
• … no cables are caught between housing edges
when the backplate is put into position
• … both housing parts are properly aligned with each
another before screwing them together never force
the housing sections together
• ... screws are tightened carefully to avoid stripping the
existing threads in the housing
• the transmitter battery is finally reconnected
1.
2.
3.
Operating notices
Converting the joysticks