User's Manual

10 / 20
34001_HB_V1
Preparation before use
The Vector unit should only be powered by a 1 S LiPo battery
PowerPack No. 78101.1.
The input voltage of the drive battery is monitored during the
flight through the telemetry function of the HoTT transmitter.
If the voltage drops under 3.2 V, the warning alarm will be
activated in the HoTT transmitter. Stop immediately the use and
charge the drive battery!
Connecting the battery
To switch on the unit connect the drive battery to the battery
connection cable (2).
Use exclusively the batteries recommended by us.
The connectors are reverse polarity protected: note the small
chamfers on the sides. Never use force – the connectors should
engage easily.
Attention
If the connection system is connected and forced in the wrong
direction, then the connector of the battery connection cable will
be ruined.
Never connect a battery with voltage higher than 4,2 V DC to
the unit! The receiver and the servo would be destroyed.
Never connect a battery to the motor socket in the unit! The
receiver and the servo would be destroyed.