User's Manual

12 / 20
34001_HB_V1
Connecting the motor unit
Use exclusively the motor units recommended by us.
The connectors are reverse polarity protected: note the small
chamfers on the sides. Never use force – the connectors should
engage easily.
Attention
If the connection system is connected and forced in the wrong
direction, then the connector of the motor connection cable will
be ruined.
Never connect a battery with voltage higher than 4,2 V DC to
the motor unit! The motor will be damaged.
Binding the unit
To be able to establish a connection to a HoTT transmitter, the
unit must at first be "bound" to "its" Graupner-HoTT 2.4 RF
module (transmitter). This process is known as “binding”. Bind-
ing is only necessary once for each combination of receiver / RF
module. However, binding can be repeated at any time if you
wish; for example, if you switch transmitters. Read also the
"BINDING" section in the manual of your HoTT transmitter!
1. Switch on transmitter
2. Connect the drive battery to the unit.
- The unit is already in binding mode.
3. Start the binding process in your HoTT transmitter (see trans-
mitter manual)
4. The successful binding process is confirmed by the trans-
mitter
- If the binding for this transmitter/receiver combination
has already been performed, the model can be used
immediately.