User's Manual

13 / 20
34001_HB_V1
Successful binding process
If the binding process was successful, the unit can be controlled
through the transmitter.
Unsuccessful binding process
If the binding process has been unsuccessful, repeat the bind-
ing process with at least 1 meter distance between transmitter
and receiver.
Binding several units
This function is described in detail in the manual of the HoTT
transmitter which support this function. The process is described
in the section "Bindign several receivers".
This function is important for model pilots who want to build and
fly their very own models or fun models which require more than
two channels. The use of the Vector Unit is in this sense very ver-
satile. In the unit there are up to 12 channels available for chan-
nel mapping.
Installing and installing possibilities of the propellers
While installing the propellers note:
 Push the propeller on the motor shaft without using violence
 Hold the motor unit from the motor mount
 The turning direction of the motor CW or CCW
 The propeller profile (curvature of the propeller)
 The turn direction of the propeller
 The incisions on the propeller
 The air flow arrow
Sketch seen from the front of the propellers!
CAUTION
Risk of injury by rotating propeller (propellers) in case the motor
(motors) starts. Always unplug the connector to the battery
before working on the propeller (propellers).
While removing the propeller note:
 Pull out the propeller
 Hold the motor from the motor case, not from the motor
mount
!