User's Manual

16 / 20
34001_HB_V1
Receiver settings for experienced
The receiver can be programmed with a suitable HoTT transmit-
ter or in connection with the SMART-BOX.
Receiver settings menu
The receiver setup menu appears in the “Telemetry“ menu under
SETTINGS / DISPLAYS or if you are using a SMART-BOX under
SETTING & DATAVIEW. How to access this menu is described
in the operating instructions supplied with your transmitter or
Smart-Box.
Low voltage warning (ALARM VOLT):
If the receiver voltage or the external voltage at channel 5 falls
below the set value, a low-voltage warning is generated by the
transmitter's RF module in the form of a "general alarm tone"
(regular beeping at a rate of approx. one beep per second) or
the "receiver voltage" speech output message.
Temperature warning (ALARM TEMP):
If the receiver temperature exceeds the set temperature, a warn-
ing is generated by the transmitter’s RF module in the form of a
"general alarm tone" (regular beeping at a rate of approx. one
beep per second) or the "receiver temperature" speech output
message.
Cycle time (CYCLE):
If your system is used exclusively with digital servos, you can set
a cycle time (frame rate) of 10 ms. If your system includes some
or uses exclusively analogue servos, you should always select
20 ms, as many analogue servos cannot process the higher
frame rate and may respond by "jittering" or "growling".
HoTT sum signal (SUMD):
This function cannot be used.
Channel 5 (C5):
This function cannot be used.
RECEIVER 1.0< >
>ALARM VOLT 3,2V
ALARM TEMP: 70°C
>CYCLE: 20ms
SUMD at C6: No
Sensor at C5 No
LANGUAGE:
English