User's Manual

18 / 20
34001_HB_V1
The small 1 x 1 to install the unit
While installing the unit note:
1. Mark the centre of gravity of the glider or model and install
battery and unit accordingly.
- This is important to let the model fly properly by itself with
the installed unit
2. The unit must be installed so that the motor is 1-2° upward
when installed as pulling motor, when installed as pushing
motor it should be installed 1-2° downward this is important:
- to let the unit have a little ascending elevator effect while
accelerating.
- to let the model not to fly downward while accelerating
3. The pushing or pulling point on the drive gear on which the
motor thrust acts
- must be always at least 10-20mm before the center of
gravity (according to the wing geometry)
- or just after the wing front edge (according to the wing
geometry) see LEO No.13301
- must always be upon the wing
- or wide under it see Hexe No.13304
4. The airflow of the propeller must be limited as less as possi-
ble, this is important:
- so that not so much thrust is required to let the model fly
(flight time increases)
- so that the controls reacts well
5. Fix the unit
- by the fixture arms through screws
- on each side with a strip of adhesive tape
- with contact glue, at best UHU-por No.596.