User's Manual

P3
LED Function
1) LIGHT ON / OFF Function
Yellow Led
① When the lights are off, LED
stay OFF
②
When the lights are on, LED stay ON condition.
（default status）
2) SPEED Attitude and Rate Function
Red Led
① Attitude mode : LED
stay ON condition.
status）
② Rate mode : LED
blinks with one second intervals.
3) Binding
and Transmitter status function.
Red Led （Status Led
）
① Show Power and Binding
② If device is not bou
nd, LED blinks with 0.5 second
intervals.
③ If device is bound, LED stay ON
condition
stay OFF
condition.
When the lights are on, LED stay ON condition.
stay ON condition.
（default
blinks with one second intervals.
and Transmitter status function.
）
nd, LED blinks with 0.5 second
condition
.
Status Discription
Red LED
Bind range
Bind status (No
bind)
blinking (1s)
Bind Success,
RX receive OK
Range Test
fast blinking
Error
Low Voltage
fast blinking
Sensor Warring
Rx Voltage,
Temp Error
fast blinking
Receive rate low,
No RX
slow blinking
Factory Error
Normal mode
Trim inc/dec
Trim 0%
Program
mode
Program mode
start
1 blink
Program mode
exit
Servo Reverse
(Normal)
Servo Reverse
(Reverse)
ATV 100%
Fail Safe mode
start
2 blink
Fail safe (trim dn,
hold)
Fail safe (trim up,
fail)
Stick
Calibration
Calibration mode
start
3 blink
Stick move done
3 blink
(3times)
Dead range set
Red LED
Green LED Buzzer
blinking (1s)
low beep(1)
on low beep(2)
on
fast blinking
low beep(2)
/2sec
fast blinking
High beep(4)
/2sec
High beep(3)
/2sec
fast blinking
High beep(2)
/2sec
slow blinking
High beep(1)
/2sec
Low beep(1)
/2sec
low beep(1)
/click
High beep(1)
/click
1 blink
low beep(1)
low beep(1)
1 blink
(5times)
low beep(1)
2 blink
(5times)
low beep(2)
High beep(1)
2 blink
low beep(2)
1 blink
(5times)
low beep(1)
2 blink
(5times)
High beep(1)
3 blink
3 blink
(3times)
3 blink
(3times)
low beep(2)
Dead
blink/3sec