User's Manual

18 / 28
S1002.PRO_jh_V1
General commissioning
Binding
The description of the binding process can be found in the Part
2 of the manual.
To use a transmitter you must associate a receiver to the transmitter.
This binding process is essential for the use of the model!
The precise binding process follow-up is described in the section
"Binding" of the Part 2 of the manual and in the related receiver
manual.
Note
The process is different for the various receiver types.
Binding-principle step by step:
1. Select the "main settings" menu in the transmitter
2. switch the RF module OFF
3. Connect the power supply to the receiver
... receiver with binding button:
• Push and hold the binding button at the receiver
• Start the binding process in your transmitter in the main settings
menu
... or receiver without binding button:
• The receiver is automatically in binding mode after switch on
• Start the binding process in your transmitter in the main settings
menu
4. If the binding process has been unsuccessful, repeat the process.
Transmitter power supply
The mz-12PRO HoTT transmitter is normally delivered with a
rechargeable battery.
Inserting the battery
Note
Pay attention when inserting the battery to the correct position and
make sure the contacts are solid.
Interruptions of the power supply to the transmitter during the use
of the models can lead to big danger for your self and for other peo-
ple.
Battery charging
Through the micro USB port you can charge the transmitter battery.
Use the included USB cable to connect the transmitter to a suitable
USB port and charge the transmitter battery. If the transmitter is
switched on the charge time is longer than if the transmitter is
switched off.
Model
memory
Wing
mix
M.Type
Phase
Servo
adjust.
Control
adjust.
D/R
Expo
Tx
adjust.
C1
curve
Stick mode
1
Timers 10:01
Rcv. Output
Bind
–––
Range test
99s
C1