User's Manual

12 / 36
S1035_Falcon_12_jh_V1
Programming a fixed-wing model
Free mixers
Note
If you wish to use the gyros, you must always set the tail type to
‘normal’ in the transmitter’s model type menu.
If your model is a delta, features a V-tail, or has two elevator servos,
you must use the receiver mixer - not the transmitter mixer - to con-
trol these control surfaces, since the gyro stabilization system will
have no effect on these servos otherwise.
The four receiver mixers work ‘downstream’ of the gyros.
If you have already programmed mixer functions in the “Wing mix-
ers” or “Free mixers” menu of your HoTT transmitter, you must
ensure that those mixers do not overlap with those available in this
menu!
Mixer
Up to four mixers can be contemporaneously programmed . You can
switch between Mixer 1, Mixer 2, … and mixer 4 in the “Mixer” line.
The following settings only affect the mixer selected in this line.
From channel
The signal source (or source channel) is mixed in to the target chan-
nel (TO CHANNEL) with a programmable amount. The method of
setting up the values is analogous to the “Free mixers” menu in HoTT
transmitters.
To channel
TO CHANNEL: part of the source channel signal (FROM CHANNEL) is
mixed into the target channel (TO CHANNEL). The mixer ratio is
determined by the percentage values entered in the “TRAVEL-” and
“TRAVEL+” lines. Select "0" if you do not want to activate any mixer.
Mixer ratio (TRAVEL-/+): in these two lines you can define the mixer
ratio in relation to the source channel (FROM CHANNEL); the value
is set separately for both directions.
Programming examples
V-tail with rudder differential
Differential is not normally necessary with this tail type. Mixer 3 is
not required if you do not need rudder differential, and TRAVEL for
mixer 2 must then be set to -100%.
Alternatively you may prefer to carry out the programming using the
transmitter menu.
FREE MIXER < >
>MIXER: 1
FROM CHANNEL: 1
>TO CHANNEL: 6
>TRIM: +0%
TRV - : +100%
TRV + : +100%
FREE MIXER < >
>MIXER: 2
FROM CHANNEL: 4
>TO CHANNEL: 3
>TRIM: +0%
TRV - : -60%
TRV + : +100%
FREE MIXER < >
>MIXER: 3
FROM CHANNEL 4
>TO CHNNEL: 4
>TRIM: +0%
TRV - : +100%
TRV + : +60%
FREE MIXER < >
>MIXER: 1
FROM CHANNEL: 3
>TO CHNNEL: 4
>TRIM: +0%
TRV - : +100%
TRV + : +100%