User's Manual

30 / 36
S1035_Falcon_12_jh_V1
Tail rotor setting with Expertmode
(See above for tail sensitivity menu item)
P tail
Tail P-factor
40-125, default setting: +80
The P tail option is responsible for effecting a harder stop with the
tail. Higher values result in a faster stop. If the P values are too high,
the tail will start to "oscillate". In such cases, the value must be
reduced again.
I tail
Tail I-factor
20-100, default setting: +70
The I-factor ensures constant pirouetting. Start with low values and
only increase them until the pirouettes are constant. If the values are
too high, this will cause the tail to oscillate slowly.
D tail
Tail D-factor
0 - 50, default setting: +15
The tail D-factor influences how the tail is stopped. If the tail bounces
somewhat when the tail is stopped, this parameter should first be
increased in 5-degree increments to test the tail stop.
Pitch->tail Swp->tail
Pitch->tail Swp->tail
0- 80, default setting: +25 0-40, default setting: +4
Static torque compensation for pitch and cyclic.
These two functions work best when they are set together.
Pitch>tail: In the event of fast pitch pumping and swashplate move-
ments, the tail should remain stable even when load is applied. If the
tail swings out briefly, the "Collect. torque" setting can be increased
until the tail stops.
On the ground, you can easily check whether the tail is working
against the torque.
Swp->tail is useful with slow-speed tail rotor with less tail power and
is then set to 1/3 of the value of pitch-> tail. With high speeds and
good rear power the value can be set to 0.
Swp-> Tail +4
Swp dynamic +65
Anti ballooning. No
Stop damp. R +5
Stop damp. L +5
Tail rotor adj.<v>
>Tail sensitiv.(5)C9
Tail rate +85
EXPO tail +40
P tail +80
I tail +70
D tail +15
Pitch->Heck +25