User's Manual

9 / 36
S1035_Falcon_12_jh_V1
Binding
The binding is only possible if, since the switch-on of the receiver, it
has not been bound to any transmitter (red LED on).
If you want to bind the receiver to a new model memory, proceed as
follows:
 Switch off the RF module in the transmitter’s “Model base set-
tings” (see transmitter’s manual)
 Distance between transmitter and receiver, minimum 1 meter
 Switch the receiver on (red LED on), wait about 15 seconds until
the red LED blinks, the receiver is now in binding mode
 Start the binding in the transmitter’s “Model base settings”
menu
 If the red LED of the receiver switches off within about 15 sec-
onds, the binding process has been concluded successfully. Your
transmitter/receiver combination is now ready for use.
 If the red LED is still blinking, the binding has not been success-
ful. In this case please repeat the entire procedure.
Interfaces
Connect the servos to the row of sockets on one end of the receiver.
The connectors are reverse polarity protected: note the small cham-
fers on the sides. Never use force – the connectors should engage
easily. The polarity is also printed on the receiver; the negative wire
(-) is brown, the positive (+) red and the signal orange. The servo
sockets of Graupner-HoTT 2.4 receivers are numbered sequentially.
The socket for channel 5 can also be programmed to deliver a (digi-
tal) sum signal (see receiver settings section).
Attention
Never connect a battery with voltage higher than 8,4V directly to
the receiver! The receiver and the connected servos would be
destroyed.