User manual

106

Program description - Model type | Winged models

• Brake offset values with a “-” preﬁx will cause

ﬂaps affected by the “Brake settings” option of the

»Wing mixers« menu to be extended when the

C1 stick is moved from rear to front, in the direc-

tion away from the pilot.

If the offset point is not set at the far end of control el-

ement travel, the remainder of travel to the end point

will be “free travel”, i. e. this “free travel” will no longer

inﬂuence any mixer available for “Brake settings” in

the »Wing mixers« menu. This idle path ensures that

all brake settings remain at “neutral”, even with minor

deviations from the limit of the brake ﬂap control. At

the same time, the effective control path is automati-

cally spread to 100 %:

+90%

SELSTO

Tail type

Motor at C1

Normal

None

Aile/flaps

1AIL

Model type

Brake Off In 1

Tip:

Preferably, the servo intended for operating any air-

brake ﬂaps that may be on the model should be con-

nected to the receiver output operated by the brake

input channel, e. g. connect airbrake servo onto (free)

receiver output 8 if input 8 has been chosen for the

“brake”, etc. A second airbrake servo is most conveni-

ently operated by way of a free mixer.