User manual

136
Program description - Dual Rate / Expo | Helicopter models
vided that this menu point is unlocked (available) on
the transmitter concerned.
Whichever switch has been assigned … the respec-
tive switch will appear in the display together with a
switch symbol indicating the switch’s direction if actu-
ated, e. g. in the «Normal» flight phase.
0%
0%
0%
EXPO
3
–––
–––
SEL
normal
Roll
Nick
Tail
Select the right-hand column at the lower edge of the
display marked with SEL and activate the value field
with a brief tap on the center SET key of the right
four-way button, the selection keys on the left or right
four-way button can now be used to alter the EXPO
value shown in the highlighted field, separately for
each of the two switch positions.
Now, for example, there is an opportunity to fly with
a linear curve characteristic with the switch in one
direction, and to preset a value other than 0 % for the
other switch direction:
33%
0%
0%
EXPO
3
–––
–––
SEL
normal
Roll
Nick
Tail
At the same time, the Expo curve will be presented in
the graph.
A simultaneous tap on the  or  keys of the
right four-way button (CLEAR) will reset a changed
entry field value displayed in inverse video back to
“0 %”.
Some examples of Expo values:
Servo travel
Servo travel
Servo travel
Stick deflection
Stick deflection
Stick deflection
Expo = +100%
Expo = +50%
Expo = –100%
In each of these examples, the Dual Rate value
equals 100 %.
Combining Dual Rate and Expo
If values have been entered for both the Dual Rate
and the Expo function, the effects of both functions
will overlap, for example, as follows:
Servo travel
Servo travel
Servo travel
Stick deflection
Stick deflection
Stick deflection
Expo = +100%, DR = 125%
Expo = +100%, DR = 50%
Expo = –100%, DR = 50%
Asymmetric setting of Dual Rate and Expo
To make an asymmetric setting, i. e. a Dual Rate
or Expo setting dependent on the direction of the
respective stick, first access the »Control switch«
menu and assign one of the C1 … C4 control
switches “C3”, for example to the desired transmit-
ter control, e. g. control 3 for the nick function. Do
not change the switching point for the stick’s neutral
position (0 %). Now return to the »Dual Rate / Expo«
menu and select the corresponding control function
(“Nick” in this example).
Now, with a brief tap on the center SET key of the
right four-way button, activate the switch assignment
and change to the expanded switches then use the
selection keys to move on to the previously defined
“C3” control switch:
100%Roll
–––
SEL
Control/Logic/fix sw
C2 C4 FX
FXi L1 L2 L3 L4
C1
C3
A brief tap on the center SET key of the right four-way
button will confirm the assignment of this switch:
100%
100%
100%
DUAL
–––
C3
–––
SEL
normal
Roll
Nick
Tail
Now use one of the selection keys to move into the
right column then move the nick stick into its appropri-
ate end-point to enter a separate Dual Rate value for
each direction, e. g. for “Nick back”
100%
100%
DUAL
–––
C3
–––
SEL
normal
Roll
Nick
Tail
77%
… and „Nick forward“:
100%
100%
DUAL
–––
C3
–––
SEL
normal
Roll
Nick
Tail
111%
The vertical dashed line shows the current nick stick
position.