User manual

159Program description - Phase assignment
A B
C D E F
2
6
5
1 normal
Phase assignment
prior.
combi
Now close one (or more, as required) of the switches
that you have assigned, and assign one of the flight
phase names from the list you selected beforehand
on the »Phase settings« menu to this switch position
or combination.
Here, for example, we assign the “Launch” phase to
the closed (“I”) priority switch “A” …
A B
C D E F
2
6
5
2 Launch
Phase assignment
prior.
combi
… if, for example, we wish to switch to this phase
regardless of the “C” … “F” switch positions, because
the same switch activates an electric motor, etc.
Use the same approach to set the other switches or
combinations of switches.
Theoretically – for the situation where all three are
closed – you could use the three single switches
shown in the example to define an additional fifth
flight phase on the »Phase settings« menu. How-
ever, since this example assumes just four flight
phases, you can leave the default phase name as
«1 Normal» for this switch position.
Leave this menu in the familiar way, with a tap on the
center ESC key of the left four-way button.
Tips:
• If you have named more phases than you current-
ly have switches defined for then this is not real-
ly problematic. You can repeat and change your
switch assignment as you wish at any point in
time. And you can also name additional phases at
any time and then assign switches to them.
• When assigning switches, check whether the
switches are already otherwise assigned to ensure
that you avoid duplicate assignments.
Important notice:
Before a phase switch is assigned, the model set-
tings configured are now to be found in the flight
phase «1 Normal», i. e. all flight phase-dependent
menus are reset to the standard configurations
for all other flight phases.
To avoid having to start from scratch in every
flight phase, you can copy over these standard
settings by using the command “Copy flight
phase” on the “Copy / Erase” menu to replace
them with flight data obtained from the «Normal»
flight phase. You then need only to make further
flight phase-specific changes to the settings.