User manual

181Program description - Wing mixers
Multi-flap menu
Important notice:
Depending on the flap pairs specified in the »Model
type« menu, page 104, this menu will present the
column “AILE2” and/or the columns “FLAP” and
“FLAP2” in addition to the “AILE” column. Since both
the columns “AILE” and “AILE2” and the columns
“FLAP” and “FLAP2” are identical except for the
label shown at the bottom right, further display of the
columns “AILE2” and “FLAP2” is avoided below for
reasons of saving space.
AI (Aileron  Flaps)
Note:
Suppressed by “2AIL 1FL”.
0%
AILE
0%
+100%
+100%
fl.pos
normal
Diff.
Ail-tr
AI
0%
FLAP
0%
0%
0%
fl.pos
normal
Diff.
Ail-tr
AI
The “AI“ line can be used to make flight-phase
dependent settings for the percentage of aileron ac-
tion to result for the camber flap pair “FLAP” and, if
present, also “FL2” when aileron control is exercised.
(In the “AILE” and, if present, “AILE2” column it is also
possible to adjust the deflection of the aileron pair, if
required.) Normally, however, the flaps should follow
the ailerons with less of a deflection, i. e. the mixer
ratio should be smaller than 100 %.
The adjustment range of -150 % to +150 % means
the direction of deflection can be adjusted, depending
on the direction of rotation of the servos, to suit the
ailerons.
A simultaneous tap on the  or  keys of the
right four-way button (CLEAR) will reset the given
active (inverse video) field to its default value shown
in the figure.
Ail-tr (Aileron trim)
Note:
Suppressed by “2AIL 1FL”.
0%
AILE
0%
+100%
+100%
fl.pos
normal
Diff.
Ail-tr
AI
0%
FLAP
0%
0%
0%
fl.pos
nor mal
Diff.
Ail-tr
AI
In this line, you specify the percentage rate with
which aileron trim is to affect “AILE”, “FLAP” and – if
present – “AILE2” and/or “FLAP2”.
The available range of values is -150 % to +150 %,
relative to the adjustment range of the trim lever.
A simultaneous tap on the  or  keys of the
right four-way button (CLEAR) will reset the given
active (inverse video) field to its default value shown
in the figure.
Diff. (Differential for aileron function)
Note:
With “2AIL 1FL”, at one level higher in the »Wing mix-
ers« menu, see figure on page 177.
0%
AILE
0%
+100%
+100%
fl.pos
normal
Diff.
Ail-tr
AI
0%
FLAP
0%
0%
0%
fl.pos
normal
Diff.
Ail-tr
AI
On this line, you set the aileron differential, plus the
differential for the FLAP and FLAP2 wing flaps – if the
latter are being activated as ailerons.
0% (normal)
50% (differential)
100% (split)
AI
FL
FL2
FL2
FL
AI
If you are unsure about the meaning of differential
travel, please read the appropriate explanation at the
start of this section on page 172.
The setting range of -100 % to +100 % permits correct
differentiation direction adjustment regardless of the