User manual

20
General operating notices
Transmitter neckstrap support bars
As standard the
mc-20 HoTT transmitter set in-
cludes a strong support system for the attachment of
a neckstrap. The mc-16 HoTT transmitter can be
retro-fitted with the transmitter support system, Order
No. 33012.2, at any time.
The support bars are inserted in the sockets in the
transmitter case, and locked in place. After the trans-
mitter has been used, they can be removed again in
similar fashion:
first press,
then turn
The support bars are installed as follows: push one
of the bars into the socket in the transmitter case,
angled towards the centre of the transmitter as shown
above. Now ensure that the retaining pin attached to
the bar is in line with the slot in the socket, and press
the bar against the spring in the direction of the trans-
mitter for a distance of about one centimetre. At the
same time fold the bar outwards (do not use force) in
order to lock it in place. Install the second support bar
in the same manner.
To remove the support bars first unlock one of the
bars by lightly pressing it inwards, and then fold it
towards the centre of the transmitter. As soon as the
retaining pin is free, you can withdraw the support bar
from its guide. Repeat the procedure with the second
support bar.
Stick length adjustment
The length of both joysticks can be continuously ad-
justed to adapt these transmitter controls to the pilot’s
preference.
Hold the lower half of the knurled grip in place then
turn the upper section to release its counter-locked
threads:
Now pull up or push down on the joystick’s end to the
desired length. When the length is suitable, tighten
the counter-locked threads of the upper and lower
sections again.
The procedure is the same if you wish to replace the
short stick-tops with the longer ones also supplied in
the set.
The following straps are available as accessories:
Order no. Description
71.26 Transmitter straps, Graupner/SJ HoTT
72.40 Transmitter straps, deluxe