User manual

279Program description - Info display
Time
1.234
0MB
ABCDEF12
2012/07/01(SUN)
11:22:33s
RFID
firmware ver.
date
time
SD-Card
If necessary, select this line with the selection keys of
the left or right four-way button and, as applicable, the
minute field. After activation of the respective value
field by a tap on the center SET key of the right four-
way button, the hour or minute can be adjusted with
the selection keys of the right four-way button. An-
other tap on the center SET key of the right four-way
button will close the given entry.
In contrast, the seconds display cannot be set direct-
ly; it can only be restarted at “00” with a brief tap on
the center SET key of the right four-way button.
Note:
If the transmitter is connected to a PC as de-
scribed on page 50, the date and time can
also be set through the PC program provided for
the respective product via the Internet page at
www.graupner.de.
The date and time are protected against data loss
due to power failure by a buffer battery for situa-
tions like a battery change, see page 18.
SD-Card
1.234
2048MB
ABCDEF12
2012/07/01(SUN)
11:22:33s
RFID
firmware ver.
date
time
SD-Card
In this line the memory capacity of a memory card in-
serted in the transmitter, if applicable, is shown in MB.
Depending on the memory capacity of the inserted
micro SD or micro SDHC memory card, it may take
several minutes until the correct value is shown after
switching on the transmitter.
available
1.234
2048MB
2012/07/01(SUN)
11:22:33s
1234MB
firmware ver.
date
time
SD-Card
available
Display of the available storage space in MB.
As mentioned before, display of the available storage
space depending on the capacity of the inserted
memory card does not appear until some time has
passed after switching on the transmitter.
The display of the available storage space in rela-
tion to the total memory capacity is shown in the line
below:
2048MB
2012/07/01(SUN)
11:22:33s
1234MB
60%
date
time
SD-Card
available
As mentioned before, display of the available storage
space depending on the capacity of the inserted
memory card does not appear until some time has
passed after switching on the transmitter.