User manual

293Programming examples - Winged models
C1-stick switchable between E-motor and spoiler
Example 5
If, contrary to the assumptions of the preceding Ex-
ample 4, the model has additional spoilers or only
spoilers, they can be incorporated into the control of
the model by means of the following programming.
Do this by programming the menus »Model type«,
»Phase settings« and »Phase assignment« in the
same manner as described under Example 4. The
settings described there in the “Brake settings” sub-
menu of the »Wing mixers« menu are only then re-
levant if an additional crow system is to be employed
in parallel with the spoilers.
With the settings described under Example 4, the
control of the E-motor and, if applicable, that of a
crow system will function as usual. Only the control
of a spoiler connected to Output 8, for example, must
additionally be programmed. For this purpose, switch
to the menu …
»Control adjust« (page 118)
… and switch into the «normal» flight phase.
Now use the selection keys to switch to the left into
the “typ” column to set the parameter in this line, e. g.
“In8” from “GL(obal)” to “PH(ase)”, so that the settings
too follow become effective on a flight-phase specific
basis.
In5
offset
0%
0%
0%
–––
0%
In6
In7
In8
–––
–––
–––
GL
GL
GL
typ
normal
fr
fr
fr
fr
SEL
PH
Afterward, switch to the “Offset” column and, following
activation of the value field with a brief tap on the SET
key of the right four-way button, change the offset val-
ue for this Input 8 value field now displayed in inverse
video until the spoilers are again “retracted”, e. g.:
In5
offset
0%
0%
0%
–––
In6
In7
In8
–––
–––
–––
GL
GL
GL
typ
normal
fr
fr
fr
fr
SEL
PH –95%
Confirm this setting with a brief tap on the center
ESC key of the left or the center SET key of the right
four-way button then switch to the left into the column
above SEL. Now switch to the flight phase «Land-
ing» then briefly tap on the center SET key of the
right four-way button. The display shows the window
…
In5
offset
0%
0%
0%
–––
In6
In7
In8
GL
GL
typ
Landing
fr
fr
SEL
95%
Move desired
control adj.
Now move the C1 stick. As soon as this is recog-
nized, “Cn1” will appear in the display instead of “fr”:
In5
offset
0%
0%
0%
–––
In6
In7
In8
–––
–––
–––
GL
GL
GL
typ
Landing
fr
fr
fr
Cn1
SEL
PH –95%
Leave the offset value in this flight phase at “0 %”. It
may be necessary to change the leading symbol of
the travel setting to reverse the control direction. Do
this by switching the travel setting from +100 % to
-100 % in the “trv” column.
Now we are practically finished. Check the program-
ming in the »Servo display« menu, which you can
reach from the base screen of the transmitter as well
as nearly every other menu position with a simulta-
neous tap on  keys of the left four-way button.
You will discover that “Servo 1” (motor control) is
controlled in the “Normal” phase and in the “landing”
phase only the spoiler is controlled at “Servo 8” and,
if applicable the aileron and flap servos – just as we
intended.