User manual

319Programming examples - Helicopter models
The “Battery type” line specifies whether the trans-
mitter is supplied with current from a “NiMH or a “Lith.”
battery, and the “Battery warning” line below it speci-
fies the voltage at which the transmitter’s low-voltage
warning should trigger. Do not enter a value that is
too low here, so you have enough time to land your
helicopter.
The setting made in the “Stick warning” line de-
termines how long the transmitter will wait after the
last actuation of an operating element before issuing
visual and acoustic warning signals to indicate it is
still switched on. Following the warning, you still have
about three minutes to actuate the transmitter so
the warning will abate. Otherwise the transmitter will
switch itself off when this time expires.
The value set in the “Touch Sense” line is a matter
of adapting the transmitter to personal preferences.
And, in the event the transmitter is to be operated in
France, the setting in the “Region” line is important:
The legal regulations in France require that the
“FRANCE” option is selected instead of the de-
fault setting “EURO”.
Note:
However, please observe the note on page 273 on
this subject.
Finally, if you are using a Bluetooth headset, you can
bind and configure it as described in the instructions
supplied with the optional Bluetooth module, Order
No. 33002.5; see the section entitled “BT Headset”.
Once these settings have been taken care of, com-
missioning continues with the menu …
»Model select« (page 79)
Use the selection keys to pick a free memory loca-
tion …
1
BD2
BD1
Mod.name
Stick mode
module
n/a
Base setup model
n/a
DSC Output PPM10
HoTT
… and call it up with a brief tap on the center SET key
of the right touch pad. In the display which then ap-
pears, use the  key of the left or right touch pad …
Select model type
… to select the “helicopter” model type. The display
immediately switches to the base screen if the selec-
tion is confirmed by a brief tap on the center SET key
of the right touch pad.
Notes:
• If the “Select model type” option has been opened,
the process cannot be canceled. Even if you
switch off the transmitter, this selection must be
made! In any case, you can undo this by subse-
quently deleting the respective model memory.
• If the “Throttle too high” warning appears, it can be
erased by turning the right-side proportional rotary
control to its backward limit.
• If battery voltage is too low, the model switchover
cannot be made due to reasons of safety. An ap-
propriate message will appear in the screen:
not possible now
voltage too low
Once this first hurdle is cleared, the connection of the
receiver built into the model at this model memory
must be made in the menu …
»Base setup model« (beginning on page 94)
To this end, switch to the line “module”:
Mod.name
Stick mode
module
1
n/a
Base setup model
n/a
BD2
BD1
DSC Output PPM10
HoTT
Note:
After confirmation of the model selection in the base
screen, if you confirm the message appearing in the
screen for a few seconds …
BIND. N/A
OK
… with a tap on the SET key of the right touch pad,
this line will be accessed automatically.
The line “module” initiates a binding process between
model memory and receiver, as described in detail
on page 94. Otherwise, you cannot address the
receiver.
Afterward, use the  selection key of the left or right
four-way button to move up to the first line and begin
with actual model programming in the “Model name”
line. Now give the model memory an appropriate
name, …