User manual

325Programming examples - Helicopter models
es or the three-stage switch is necessary.
The assignment of the switch takes place in the
menu …
»Phase assignment« (page 158)
Under “C” and “D”, for example, assign the one of the
two standard 3-way switches mounted into the switch
panels, e. g.:
Phase assignment
A B
C D E F
1 Normal
6
5
prior
combi
Now the given switch position must be assigned to
the respective flight phase in the »Phase settings«
menu. Since these phases already have names, the
name «1 Normal» will initially appear at the right in
the display. If the already assigned autorotation switch
was activated, the following warning message ap-
pears in the display:
Phase assignment
A B
E F
1 Normal
prior
combi
Autorot
As a reminder:
The autorotation phase has absolute precedence.
Therefore, move the autorotation switch back again
then put the selected switch, in the example the
three-stage switch connected to switch plug-in loca-
tions 5 and 6, initially to one of its limit positions. Now
use the selection keys to change to the bottom right
and activate this entry field:
A B
C D E F
6
5
1 Normal
Phase assignment
prior
combi
Now use the selection keys to select the desired flight
phase for this – for example “2 Hover” …
A B
C D E F
6
5
2 Hover
Phase assignment
prior
combi
… and confirm this selection with a brief tap on the
center SET key of the right touch pad or go ahead
and put the switch into its other limit position and
define the name for this new switch position, such as
«3 Speed».
A B
C D E F
6
5
3 Speed
Phase assignment
prior
combi
The switch’s middle position then receives the name
“1 Normal”:
A B
C D E F
6
5
1 Normal
Phase assignment
prior
combi
Note:
Exchanged or different name assignments for the
three switch positions are, of course, also possible.
Thus, for example, implementation of a programmed
speed controller (as described beginning in the next
column) can make a sequence like “normal / hover /
acro” quite logical.
The model settings made before the assignment of
a phase switch are now in the flight phase “Normal”.
This is the phase which is called after the above defi-
nition in the switch center position.
This normal setting, which was already tested in
flight, can be copied to a different flight phase so that
flying can take place in the same manner in every
phase at first. For this purpose, use the menu …
»Copy/Erase« (page 80)
=>
=>
=>
=>
=>
=>
Copy flight phase
Erase model
Copy model–>model
Export to SD
Import from SD
With the operation of the flight phases, it is possible
to carry out changes in the phase-dependent menu
for each individual phase. Since the mc-16 HoTT
and mc-20 HoTT transmitters has digital trim-
ming, in addition to the flight-phase dependent menu
settings in the helicopter program, the trim positions
of roll, nick and tail rotor stick can also be selected
for storage on a flight-phase dependent basis, see
»Stick mode« menu, page 116:
STARLET
#02
2:22h
Stp
Flt
0:00
0:00
5.5V
3.9V
M
HoTT