User manual

33Transmitter description - Warning notices
Warning notices
Batt. must
be re-
charged!!
Operating voltage is
too low
BIND. N/A
OK
„Bind not available“
A receiver has not yet
been bound to the
currently active model
memory. A brief tap on
the SET key will cause
a direct jump to the ap-
propriate option.
Power on warning
is active!
If no controls are oper-
ated on the transmitter,
it switches itself off au-
tomatically after about
three minutes.
Attention!
Switch-OFF
the Receiver first!
This warning appears
if you try to change
models in the »Model
select« menu with the
receiver of the previ-
ously active model still
switched on.
CAN‘T
RECEIVE
DATA
OK
No bound receiver in
range
Please select
RF on/off?
ON OFF
Only for a receiver
that has already been
bound:
Please select RF „on“
or „off“? RF
RF
must be
OFF
OK
Request to switch off
the RF section.
Warning notices
Fail Safe
setup
t.b.d.
Failsafe has not yet
been activated
Thr
too
high!
The throttle stick of a
fixed-wing model, or
the throttle limiter of
a helicopter, is too far
in the direction of full-
throttle.
No
pupil
signal
Connection between
teacher and pupil trans-
mitter is interrupted
SD-CARD
INSERT
OK
No SD or SDHC mem-
ory card in the card slot
or card is not legible
• If battery voltage is too low, a model switch is
blocked for reasons of safety. An appropriate mes-
sage will appear in the screen:
not possible now
voltage too low
• Is the “wireless teacher/pupil connection” that was
active when the transmitter was last used to be
continued, ACT or switched off INH?
Please select
Trainer link?
ACT INH
Please select
Trainer link?
ACT INH