User manual

41Transmitter description - Telemetry data display
0.0V 0m/3s
BAT1 0m/1s
BAT2
0.0V T2 0°C
T1 0°C
0
1H0.00
2H0.00
3H0.00
4H0.00
5H0.00
6H0.00
ALT 0m
7H0.00
0.0V 0A
If attached to the receiver, this display will depict the
data acquired by an Electric-Air module, order no.
33620. More details about this module can be found
in the appendix or in Internet at www.graupner.de in
the web page for the given product.
Depending on how this module is equipped with sen-
sors, this screen can permanently display the data
shown in the adjacent table.
The current voltage of up to two batteries (BAT1 and
BAT2), up to two temperature measurements (T1
and T2), current altitude with respect to the starting
location, the model’s ascent/decent rate in m/1 s and
m/3 s and, in the middle of the screen, the current
draw currently being taken from a power source.
Along the right edge of the screen is a table of alter-
nating values for cell voltages at balancer connec-
tions (L) or voltages for up to 7 attached battery cell
packs (H).
The displayed items are as follows:
Value Explanation
V current voltage
A current current
BAT1 /
BAT2
battery 1 or 2
ALT current altitude
m/1s m/1 s ascent/decent rate
m/3s m/3 s ascent/decent rate
T1 / T2 temperature of sensor 1 or 2
L or H cell voltage of cells 1 … max. 14
L = balancer connection 1
H = balancer connection 2
Micro-copter display
0mAh
0:00
0.0V
0km/h
0
I:
Dir:
Alt: 0m
0°
0A
0m
0°
This screen displays the data generated by a HoTT-
compatible micro-copter. Key, reading from top left to
bottom right:
Value Explanation
V Actual voltage
„0:00“ Period switched on
mAh Battery capacity consumed
„0“ Altitude relative to take-off point,
according to GPS system
km/h Speed over ground, according to GPS
system
Alt Actual altitude
Dir Direction of movement
I Actual current
m Distance from take-off point, according
to GPS system
° Position in degrees relative to take-off
point, according to GPS system
Any messages from the micro-copter sensor are
displayed in the bottom line of the screen, which is
empty in the screen-shot shown above.
ACCU
0.0V
0.0A
0mAh
This display depicts current voltage, current cur-
rent draw and, if attached, the expended capacity of
“Batt 1” connected to the Electric-Air module (order
no. 33620).
SENSOR 1
0.0V
0°C
SENSOR 1
If attached, this display depicts currently measured
voltage and temperature from a temperature/volt-
age sensor (order no. 33612 or 33613) connected
to “T(EMP)1” of the Electric-Air module (order
no. 33620).
SENSOR 2
0.0V
0°C
SENSOR 2
If attached, this display depicts currently measured
voltage and temperature from a temperature/volt-
age sensor (order no. 33612 or 33613) connected
to “T(EMP)2” of the Electric-Air module (order
no. 33620).