User manual

43Transmitter description - Telemetry data display
Vario
0.0
0
m
m
s
If attached, this display will depict altitude relative to
location or starting location (in m) as well as the cur-
rent rate of ascent/decent (in m/s) from data acquired
by a Vario module (order no. 33601).
Text display
If the corresponding sensors are available, text from
them showing 2 x 10 or 3 x 7 characters can be
superimposed in the two following displays when
required:
GPS
RECEIVER
AIR ESC
GENERAL
ELECT. AIR
VARIO
GPS
N
RXSQ 0
DIS 0m
ALT 0m
0.0m/1s
0m/3s
N 0°00.0000
E 0°00.0000
W
E
S
Kmh
0
If attached to the receiver, this display will depict the
data from a GPS module with integrated Vario, Order
No. 33600.
Aside from the model’s current position and speed,
the center section of this screen will also display
current altitude with respect to the starting location
as well as the model’s current ascent/decent rate in
m/1 s and m/3 s, current reception quality and the
model’s distance from its starting location.
The displayed items are as follows:
Value Explanation
W / N / E / S west / north / east / south
Kmh speed
RXSQ return channel signal quality
DIS distance
ALT current altitude with respect to starting
m/1s m/1 s ascent/decent rate
m/3s m/3 s ascent/decent rate
Micro-copter display
0mAh
0:00
0.0V
0km/h
0
I:
Dir:
Alt: 0m
0°
0A
0m
0°
This screen displays the data generated by a HoTT-
compatible micro-copter. Key, reading from top left to
bottom right:
Value Explanation
V Actual voltage
„0:00“ Period switched on
mAh Battery capacity consumed
„0“ Altitude relative to take-off point,
according to GPS system
km/h Speed over ground, according to GPS
system
Alt Actual altitude
Dir Direction of movement
I Actual current
m Distance from take-off point, according
to GPS system
° Position in degrees relative to take-off
point, according to GPS system
Any messages from the micro-copter sensor are
displayed in the bottom line of the screen, which is
empty in the screen-shot shown above.