User manual

81Program description - Copy / Erase
01
03
04
ULTIMATE
02
GRAUBELE
STARLET
BELL47G
Copy to model:
05

free

R12
R12
R12
–––
After confirming the selected model memory with a
tap on the SET key, a confirmation request will ap-
pear:
Modell really
ULTIMATE
to be copied?
NO
YES
01
03

free

A NO response will cancel the process and return
the screen to the originating screen. If the  YES
response is selected and confirmed with a tap on the
SET key then the selected source model will be cop-
ied into the selected model memory destination.
Note:
In addition to model data, binding data is also copied
by this process. This means that a receiver system
which was/is bound to the original model memory can
also be operated by its copy in the SAME transmitter
without establishing the bond again.
Exporting to SD card
Use the  selection keys of the left or right four-
way button to select the “Export to SD” sub-menu
then tap on the SET key.
=>
=>
=>
=>
=>
=>
=>
Copy flight phase
Erase model
Copy model–>model
Export to SD
Import from SD
Choose the model to be exported with the  selec-
tion keys of the left or right four-way button …
01
03
04
ULTIMATE
02
GRAUBELE
STARLET
BELL47G
export to SD-CARD:
R12
R12
R12
–––
After confirming the selected model memory with a
tap on the SET key, a confirmation request will ap-
pear:
modell
ULTIMATE
export ?
NO
YES
01
SD-CARD
A NO response will cancel the process and return
the screen to the originating screen. If the  YES
response is selected then confirmed with a tap on the
SET key, the selected model will be copied to the SD
card.
Notes:
• Should the notice …
SD-CARD
INSERT
OK
… appears instead of a screen for model selec-
tion, there is no SD card in the transmitter’s card
slot, see page 24.
• In addition to model data, binding data is also cop-
ied by this process. This means that a receiver
system which was/is bound to the original model
memory can also be operated in the SAME trans-
mitter by its copy without establishing the bond
again.
• An exported fixed-wing model will be stored on the
memory card in the \\Models\mc-16 respective-
ly \\Models\mc-20 folder with a filename format of
“aModelname.mdl” and a helicopter model with a
filename format of “hModelname.mdl”. On the oth-
er hand, if a “nameless” model is exported, its data
will be stored on the memory card under “aNo-
Name.mdl” or “hNoName.mdl”, as appropriate.
• Some special characters that can be used in mod-
el names are subject to specific restrictions asso-
ciated with the FAT or FAT32 file system used by
the memory cards and these special characters
will be replaced during the copy process with a til-
de (~).
• A model file already on the memory having the
same name as the file to be copied will be over-
written without warning.