User Manual

on products.
Choose the detected GRAUPNER_ESC WiFi.
2.1) Switch on “WiFi” setting in a smart phone.
2.2) Then, chose “GRAUPBER_ESC_(XXXX) at WiFi, then password box appears.
2.3) Initial WiFi password is 1234567890
. Insert the password then check WiFi
connection.
2.4) Once it is connected, click on “BL-WM APP” in a smart phone. Once APP start screen
is pressed, it should move into a main screen.
2.5) Click at the right bottom of the main screen, then select WiFi item. Change
WiFi name(SSID) and password as other customers can also use the provided initial
ID and password. Reset WiFi and connect to avoid any confusion.
Note: After changing name or password of BL-WM, research again WiFi then set and
proceed.
Note: In case you forget the password, please update BL-WM using grStudio then set
WiFi and proceed. After this wired update, WiFi module is initialized. Please refer to the
homepage on the detailed operation.
2.6) After all of the above procedures are executed, overall setup on BL-WM is complete.
Once a motor is operated. WiFi is automatically On and Off, except for Live Mode. Thus,
we recommend you to switch off the application in a smart phone to reduce RF
interference during driving.
5. LED Status (LED status)
YELLOW LED is ON : WiFi module is ON
YELLOW LED flashes : WiFi module is OFF
RED LEDflashes : Command comes from smart phone
RED LED is ON : BL-WM is being updated in wired condition.
RED LED flashes three time : Initialization is complete. Default ID and password are set.