User's Manual

239
Detail program description - Control adjust
If the battery voltage is too low, you cannot switch •
models for safety reasons. A corresponding message
appears in the display:
not possible now
voltage too low
Once this fi rst hurdle is cleared, the connection of the
receiver built into the model to this model memory can
be made in the menu …
""Basic model settings" (page 68 … 73)
. For this purpose, switch to the line "RF bind":
1
n/a
n/a
BD1
GRAUBELE
BD2
RF transmit n/v
OFF
Mod.name
Stick mode
RF BIND
BASIC SETTINGS, MODEL
Notice:
After confi rmation of the model selection in the base
screen, if you confi rm the message appearing in the
screen for a few seconds …
BIND N/A
OK
… by pressing the SET key of the right touch pad, you
automatically come to this line.
In this line you delete the connection process between
model memory and receiver, as described in detail on
page 69. Otherwise, you cannot address the receiver.
Afterwards, using the arrow keys c of the left or right
four-way pad, move up to the fi rst line and begin with the
actual model programming in the "Mod. Name" line:
1
n/a
BD2
BD1
n/aR12
bind
Mod.name
Stick mode
RF BIND
BASIC SETTINGS, MODEL
Rcv Ch Map
Now enter the "Model name" here by briefl y pressing
the central
SET key of the right touch pad to switch to
the character map:
!"#$%&’()+,–./012
3456789:;
Mod Name
GRAUB
FGHIJKLMNOPQRSTUVWX
YZ[¥]^_`abcdefghijk
?@AB CDE
If applicable, the defaults adopted from the "General
settings" menu for "Stick mode" and "DSC output"
are also checked and changed as necessary.
In the menu …
"Model type"
Tail type
Motor at C1
Normal
None
Aile/flaps
1AIL
M O D E L T Y P E
Brake Off
In 1+100%
SEL
… the principle arrangement of the servos in the model
is selected and communicated to the transmitter. The
following selections are available:
"Motor at C1"
"none"•
Trimming works independently of the jo
ystick position
and the "Brake settings" submenu of the "Wing
mixers" menu, beginning on page 146, is available
without limitation.
The "Throttle too high" warning message, see
page 36 and/or 61, and the "Motor stop" option are
deactivated.
"(Idle) front or rear"•
C1 trimming is affected in the front or rear and the
"Motor stop" option is activated.
If the throttle joystick is too far in the full throttle
direction when switching on the transmitter, this is
indicated to you with the warning message "Throttle
too high".
In parallel to this, the "Brake settings" submenu of
the "Wing mixers" menu, beginning on page146,
is only available if "none" is entered in the "Motor"
column for the currently active fl ight phase in the
"Phase settings" menu, page 128.
In the next two lines, the principle arrangement of the
servos in the model is selected and communicated to
the transmitter:
+100%
SEL
Tail type
Motor at C1
Normal
None
Aile/flaps
1AIL
M O D E L T Y P E
Brake Off In 1
Tail type: "Normal", "V-ta(il)", "Delta/fl " or
"2ELSv3+8"