User's Manual

282
Detail program description - Control adjust
99sec
PPM10
8I
ON
DSC Output
Autorotation
RF transmit
BASIC SETTINGS, MODEL
RF Range Test
The selected switch should be in a location on the
transmitter which is easily within reach – without
releasing a joystick – e. g. above the pitch joystick.
Notice:
More more information about the setting of this
"emergency shutoff", see the beginning of the second
following double-page.
Another tip:
Make a habit of giving all switches a common switch-on
direction; then a quick glance over the transmitter prior
to the fl ight should suffi ce – all switches off.
The possible settings of the lines "Automatic C1
position" and "Motor stop" are not of interest at fi rst.
Additional settings specifi c to helicopters are made in
the menu …
"Helicopter type" (page 86)
Under "Swashplate type", select the control of the
swashplate and/or the pitch function. In this example:
"3Sv(2rol)".
The lineLinear swashpl." is not of interest at fi rst.
In the line "Rotor direct" you defi ne whether the
rotor - as viewed from above - rotates to the right or left.
In other words, whether it rotates counterclockwise or
clockwise. In this example "right".
With the default "Pitch min" adopted from the "General
…
1
n/a
bind
BD2
BD1
n/a
R12
Mod.name
Stick mode
RF BIND
BASIC SETTINGS, MODEL
Rcv Ch Map
… which is comprised of the characters available for
selection on the second screen of the "Mod. Name" line:
!"#$%&’()+,–./012
3456789:;
Mod Name
STARL
FGHIJKL MNOPQRSTUVWX
YZ[¥]^_`abcdefghijk
?@ABCDE
After entering the "Model name" the specifi cations for
the "Stick mode" and "DSC output" adopted from the
"General settings" are checked again, for which you
can change the storage location, if applicable.
An additional option is activated in the line
"Autorotation". Even if you are not an advanced pilot,
the autorotation switch should at least be set an an
emergency shutoff switch for the motor.
For this purpose, select the line "Autorotation", activate
the switch assignment by briefl y pressing the central
SET key of the right touch pad and move one of the two-
stage s
witches, e. g. SW 8, to the ON position:
settings", it is checked whether the entry "front" or "back"
corresponds to your habits and changed, if applicable:
3Sv(2rol)
SEL
Linear. swashpl.
Swashplate
no
Rotor direct
right
HELI TYPE
Pitch min. back
"Expo thro lim." in the bottom line of this display is not
of interest yet.
By now, the servos should be plugged into the receiver
in the intended sequence:
Receiver power supply
Free or aux. function
Free or aux. function
Tail rotor servo (gyro system)
Roll 1 servo
Pitch-axis 1 servo
Free or speed governor or aux. function
Receiver power supply
Collective pitch or roll 2 or
Pitch-axis 2 servo
Free or aux. function
Throttle servo or speed controller
Gyro gain
Free or aux. function
Free or aux. function
Notice:
Please note that with the newer Graupner mc and
mx remote control systems the fi rst pitch servo and
the throttle servo are reversed when compared with the
older systems.
The degrees of mixing and mixing directions of the
swashplate servos for pitch, roll and nick are already
preadjusted to +61 % in the menu ...