Operation Manual

System Menu
Using the system for the first time and programming
the basic transmitter data
14 System Menu
Software Structure
The software is divided into two menus, which are
activated in different ways.
1. System Menu
Adjusting the basic transmitter functions.
2. Set-Up Menu
Selecting, activating and programming the model
specific data.
In each of these menus, the individual codes can be
called up in rotation by the ROLL UP (upwards) or
ROLL DN (Roll Down, downwards) buttons. When
you reach the bottom code, the ROTART SELECT
system returns you to the start of the list again, until
you either leave the System or Set-Up Menu by
pressing ENTER ( ROLL UP and ROLL DN keys
simultaneously), or by switching off the transmitter
and thereby resetting it to normal operation.
To prevent accidental reprogramming, the System
Menu can only be activated if the transmitter is
switched off first. This makes it impossible for you to
accidentally alter programmed these functions, e.g.
switching model memory or changing modulation
mode (FM-PPM/PCM), while you are using the
system to control a model. Since the transmitter is
not producing a modulated signal in this mode, it is
impossible to transmit a signal to the receiver during
this basic programming.
Basic method of using the System Menu
First you need to select the code you wish to alter by
pressing the ROLL UP or ROLL DN button. Within
this code, you select the function you require using
the INC or DEC buttons.
Entering the System Menu
Simultaneously press the ROLL UP and ROLL DN
buttons (= ENTER ) whilst turning the transmitter on.
An acoustic signal sounds. The program is now in
the System Menu. The accompanying flow chart
shows the programs of the primary system, whose
functions are shown in the transmitter display. By
repeat pressing of ENTER the software leaves the
basic programming and automatically returns to
normal transmitter operation.
Block diagram of the System Menu
Leave the Menu at any place with ENTER .