Operation Manual

Reset, erase data & reprogram the basic values Switching Model Memory 1 – 20
(access via System Menu) (access via System Menu)
System Menu 17
DAT
A
INITIALISATION
MODEL SELECT Receiver Connections
(
Channels 1
–
8
)
Before you re-program a model memory, you should
reset all data using this code in order to ensure that
all parameters and functions are reset to the default
settings.
When you select the “RST” function, the number of
the model memory in the bottom line of the display
flashes. This is the memory whose settings are to be
erased. The actual erasure occurs when you press
the CLEAR button. As soon as the model number
ceases to flash the erasure has taken place.
Re-initialised data after reset:
In the System Menu:
Model Name Model number and current model type
Throttle Direction Normal (“NORM”)
NAUTIC program off (“OF”)
The settings for type of modulation, model number, stick mode
and model type are unchanged.
In the Set-Up Menu
Dual-Rate = 100%
Exponential = Linear (“LN”)
Servo Reverse = Normal (“NORM”)
Servo Neutral = 0
Servo Travel = 100%
Mixer Values = Initial default values
The mc-16/20 transmitter allows you to store all the
settings for 20 different models.
After selecting the System Menu code “MDL”, by
pressing the ROLL UP or ROLL DN button, press
the INC or DEC buttons to select the model. All the
adjustments which you subsequently make will then
apply to the model number displayed in this menu.
The model type can be called up in the display by
pressing the CH SEL button.
The servos must be connected to the receiver
outputs as shown in the diagrams below:
See the Helicopter section for those connections.