Operation Manual

24 Fixed Wing Models
Example 2: To link the stopwatch with the throttle,
CH SEL is pressed when the display shows “OF”
(timer OFF). The display changes to "+-" indicating
the switching direction needs to be selected using
the INC / DEC buttons. This controls whether the
stopwatch runs with the throttle above the neutral
position, display "1H" (ch 1 = High), or below the
neutral point with display “1L” (ch 1 = Low).
If CH SEL is pressed again, the direction is retained
and will be used later. Where the display indicates
"OF", it means only that the alarm timer is off and the
stopwatch is active. This control only works with
either "1H" or "1L" selected. To deactivate throttle
stick operation, with the display showing "OF", press
CH SEL and the display will show "1H" or "1L".
Press CLEAR to return the display to "+ -", showing
the throttle stick has been decoupled. Pressing CH
SEL again returns to the display to "OF".
In the active condition the stopwatch does not run
with the throttle stick in idle position. CLEAR returns
the transmitter counter to the initial setting of “000".
Example 3: The switching function, described in (2.),
can also be used with the alarm timer. Select the
switching direction described above ("1H" or "1L")
then press CH SEL (display shows "OF"). As in (1.)
the time interval is adjusted in 10s steps using
INC / DEC . In the normal display mode, the alarm
timer is now controlled by the throttle stick.
To deactivate: Select code "TMR" and press
CLEAR . The display changes to "OF" (alarm timer
OFF = stopwatch mode). A press of CH SEL
changes the display to "1H" or "1 L", which is
cancelled by pressing CLEAR .The display will now
show "+ -", indicating that the throttle control is
decoupled from the timer.