Operation Manual

STANDARD Block Diagram STANDARD (Fly) “FL”
Model Type Described
28 Fixed Wing Models
Included under the STANDARD type are all motor
and sailplane models, with which control over
elevator, rudder, ailerons, engine throttle or rpm
(and/or airbrakes for sailplane models) is possible. In
this programme it is also possible, via additional
control paths for auxiliary functions, to control
features like retractable landing gear, cable release,
mixture adjustment or also landing flaps (and/or
variable flaps for sailplane models). All options,
which are for this configuration possible and
meaningful, are available here.
Some special mixers, such as combi-mix (aileron -
rudder), elevator adjustment during flap operation
and an elevator - flap mixers to the assist the
elevator in manoeuvring, are already configured.
Beyond that three freely programmable mixers are
available for applications such as aileron or flap
control using two separated servos or more complex
mixing functions.
The program area titles "WING" covers the programs
for delta and V-tail models. With delta and flying wing
models, elevator and aileron share the same control
surfaces on the left and right trailing edge of the
wing. With V-tail models the elevator and rudder
functions are linked with one another in an
appropriate way to control the model.
Allocation of Receiver Connections (ch 1 – 8)
The servos must be connected to the receiver
connections as follows: