Operation Manual

Aileron  Rudder Mixer Flap  Elevator Mixer
(access via Set-Up Menu) (access via Set-Up Menu)
58 Fixed Wing Models
COMBI-MIX FLAP  ELEVATOR
MIXER
If the "ALD" subroutine were previously switched off
by pressing CLEAR , can move the elevators, flaps
and airbrake to their pre-determined auto-landing
positions by operating external switch 5.
The settings for the control surfaces must be
determined experimentally during flight and then
adapted to the requirements.
Warning
:
If the automatic manoeuvre, see page 56 is
simultaneously switched on, it will be inactive when
control function 1 is below the switching point for
auto-landing!
In the case of operating the ailerons, the rudder is
deflected by a programmable mix proportion. The
rudder can, however, be steered separately at any
time with priority.
After call of the code "A-R", the mix proportion is
adjusted using the INC / DEC buttons and is stopped
to automatically at the maximum value of ±125%.
The combi mixer can also be disabled by an external
switch attached to socket 3 on the transmitter board.
To assist the elevator with close turning flight and
aerobatics, the flaps can be linked to the elevator
and are driven out proportionally to the increase the
wing lift. The value in the code "E-F" can be varied
using, the INC and DEC buttons between 0 and
±125%. The mixer can be also switched off with an
external switch connected to socket 4.