User's Manual

29
Description of transmitter
As soon as you operate one of the two rotary controls
CTRL 7 + 8 on the centre console
, a small symbol ap-
pears to the right of the two vertical position indicators:
At the same time the position display of the two central
vertical bars switches for the duration of the actuation
from the display of the current trim position to the cur-
rent position of the rotary controls CTRL 7 + 8.
As you would expect, the left-hand bar represents the
position of the left-hand rotary control CTRL 7, and the
right-hand bar refl ects the position of CTRL 8 (however,
both horizontal bars continue to show the current posi-
tion of the corresponding transmitter stick trim levers):
GRAUBELE
#01
3:33h
stop
flt
K78
0:00
0:00
RX0.0V
50%
5.2V
HoTT
M
About two seconds after you cease operating one of the
two rotary controls, the screen reverts to a display of the
current position of the four trim levers for the two dual-
axis stick units.
Position display
Rotary proportional controls CTRL 7 and 8
To prevent programming errors, it is possible to lock the
four-way buttons, and with them access to all the set-up
options, from the base display of the mx-12 HoTT
transmitter by pressing the ESC and SET buttons simul-
taneously f
or about two seconds. This is indicated by an
inverted key symbol at the centre point of the trim bars:
GRAUBELE
#01
3:33h
stop
flt
«normal »
K78
0:00
0:00
5.5V
50%
5.2V
HoTT
M
The lock is immediately active, but the control system
remains ready for use.
Pressing the ESC and SET buttons again for about two
seconds disengages the loc
k: the next time you switch
the transmitter on, the lock is also disengaged.
Input lock
33112_mx12_HoTT_2_GB.indd Abs8:2933112_mx12_HoTT_2_GB.indd Abs8:29 06.06.2011 19:39:3406.06.2011 19:39:34