User's Manual

141
Program description: Info display
Time
RFID
firmware ver.
date
time
SD-CARD
(FRI)
1.11
0KB
ABCDEF12
2011/03/11
11:22:33s
If necessary, you can select this line, and the minutes
fi
eld, using the arrow buttons of the left or right-hand
touch-key. A brief press on the central SET button of the
right-hand touch-key activates the corresponding value
fi eld, and you can then adjust the hours or minutes
using the arrow buttons of the right-hand touch-key. A
further brief press on the central SET button of the right-
hand touch-key concludes the entry process.
Note that the seconds display cannot be set directly;
instead it can be reset to “00” with a touch of the central
SET button of the right-hand touch-key.
Notes:
The date and time of day can also be set using the •
PC prog
ram available for the corresponding product
on the Internet at www.graupner.de; this requires that
the transmitter should be connected to a PC in the
appropriate manner.
The date and time are protected from data loss due •
to power failure - for example, when the battery is
swapped - by a user-replaceable buffer battery.
SD card
RFID
firmware ver.
date
time
SD-CARD
(FRI)
1.11
2048KB
ABCDEF12
2011/03/11
11:22:33s
This line displays the storage capacity in KB of a memo-
ry card installed in the tr
ansmitter.
Depending on the memory capacity of the micro-SD
or micro-SDHC memory card fi tted in the transmitter,
it may take several minutes for the display to show the
correct value after you switch the transmitter on.
available
firmware ver.
date
time
SD-CARD
(FRI)
1.11
2048KB
2011/03/11
11:22:33s
available 1234KB
Display of the available memory in KB.
As already mentioned, it may tak
e a certain amount of
time for the available memory to be displayed after you
switch the transmitter on, depending on the total capac-
ity of the installed memory card.
The next line down displays the available memory in
relation to the total memory capacity:
date
time
SD-CARD
(FRI)
2048KB
2011/03/11
11:22:33s
available 1234KB
60%
As already mentioned, it may take a certain amount of
time for the a
vailable memory to be displayed after you
switch the transmitter on, depending on the total capac-
ity of the installed memory card.