User's Manual
Table Of Contents
- Programming Manual 33116.mx-16 HoTT.1.gb
- Contents
- Safety Notes
- Safety notes and handling instructions relating to Nickel-Metal-Hydride rechargeable batteries
- Introduction
- Operating Notes
- Description of transmitter
- Using for the first time ...
- Installation Notes
- Definition of terms
- Assigning switches and control switches
- Digital trims
- “Binding” transmitter and receiver
- What is a mixer?
- General notes regarding freely programmable mixers
- Fixed-wing model aircraft
- Receiver socket assignment for "normal" models
- Receiver socket assignment for models of the “Delta / Flying wing” type
- “Binding” transmitter and receiver
- Detailed description of programming
- mx-16 HoTT programming techniques
- Model helicopters
- Receiver socket assignment
- “Binding” transmitter and receiver
- Detailed description of programming
- Programming example
- Appendix
- Guarantee certifi cate
27
Description of transmitter
Changing the language
Use the arrow buttons of the left or right-hand touch-key
to move to the “VOICE” line:
¿ HIDDEN MODE ¿
CONTRAST
LANGUAGE
0
ENGLISH
VOICE
DEUTSCH
Activate voice output by pressing the central SET button
of the right-hand touch-key:
¿ HIDDEN MODE ¿
CONTRAST
LANGUAGE
0
ENGLISH
VOICE
DEUTSCH
Now use the arrow buttons of the right-hand touch-key
to replace the default language “DEUTSCH” (German)
with the language of your choice. For example:
¿ HIDDEN MODE ¿
CONTRAST
LANGUAGE
0
ENGLISH
VOICE
ENGLISH
Confi rm your selection by briefl y pressing the central
SET button of the right-hand touch-key again: the
selected voice package is now loaded into the transmit-
ter’s memory:
¿ HIDDEN MODE ¿
CONTRAST
LANGUAGE
0
ENGLISH
VOICE
ENGLISH
22/100%
I
The loading process is fi nished when the progress bar
at the bottom edge of the screen disappears:
¿ HIDDEN MODE ¿
CONTRAST
LANGUAGE
0
ENGLISH
VOICE
ENGLISH
Finally switch the transmitter off to conclude the proce-
dure.
All the settings stored in the transmitter are retained in
full even after you have switched languages.
Notes:
If the warning message …•
RF
MUST BE
OFF
OK
… appears, then the transmitter’s RF section is still
active. Switch this section off in the “RF module” line
of the “Basic settings” menu, and repeat the proce-
dure.
If the warning …•
SD-CARD
INSERT
OK
… appears, then there is no memory card in the card
slot, or the card cannot be read.
If the war
ning …•
MISSING
IMPORT
DATA
OK
… appears, then there is no suitable voice fi le on the
SD card you have inserted.