User's Manual

43
Fixed-wing models: receiver assignment
Installation notes
The servos MUST be connected to the receiver
outputs in the following order:
Outputs not required are simply left vacant.
Please note the following points in particular:
If you are using only one aileron servo, receiver out-•
put 5 (right aileron) is left unused;
it can also be used
for another purpose if you select “1 AIL” in the “Basic
settings” menu.
If you are using only one fl ap servo, receiver output 7 •
(right fl ap) MUST be left unused, assuming that you
have selected “2 FL” in the “Basic settings” menu.
Please also read the information on the following
pa
ges.
Receiver soc
ket assignment for models with up to two ailerons and two fl aps, plus “normal” tail type, V-tail,
and two elevator servos (3 + 8)
Servo
4 8 V
C 577
Bes Nr 4101
Receiver battery
Switch harness
Telemetry sensor
Y-lead,
Order No. 3936.11
Receiver
3 = Elevator / left V-tail
2 = Aileron / left aileron
8 = 2nd elevator / aux. function
7 = Right fl ap / reserve
5 = Right aileron / reserve
4 = Rudder / right V-tail
1 = Throttle / brake
6 = Flap / left fl ap / reserve