User's Manual

130
Program description: Telemetry menu
Value Explanation
S Signal quality in % for the signal
arriving at the receiver
TD Reception performance in dBm
E Number of lost receiver data packets
RD Reception performance in dBm of the
signal picked up by the receiver
VC Actual receiver operating voltage in
Volt
VM Lowest receiver operating voltage in
Volt since the last time it was switched
on
VOICE TRIGGER
First select the desired menu line using the arrow but-
tons cd of the left or right-hand touch-key …
TELEMETRY
SETTING & DATA VIEW
SIMPLE DATA VIEW
RF STATUS VIEW
VOICE TRIGGER
… then press the central SET button of the right-hand
touch-key to open the selected sub-menu:
REPEAT
VOICE TRIGGER
REPEAT 1SEC
TRIG
TRANSFER
RECEIVER
–––
–––
Speech output is available via the headphone socket,
but not until you have at least assigned a switch in the
“REPEAT” line. This is accomplished as described in
the section entitled “Assigning switches and control
switches” on page 39:
VOICE TRIGGER
TRANSFER
RECEIVER
push desired switch
into position ON
VOICE TRIGGER
REPEAT 1SEC
TRIG
TRANSFER
RECEIVER
–––
3
All the time the assigned switch is closed, the last
speech output is repeated for the period set to the left of
the switch.
TRIG
If you assign a switch in the “TRIG” line - preferably one
of the two momentary buttons SW 1 or SW 9 - you can
use it to cycle through the speech output selected in the
menus described in the following section.
VOICE TRIGGER
TRIG
TRANSFER
RECEIVER
9
3REPEAT 1SEC
TRANSFER
Select the desired menu line using the arrow buttons
cd of the left or right-hand touch-key …
VOICE TRIGGER
REPEAT 1SEC
TRIG
TRANSFER
RECEIVER
3
9
… then briefl y press the central SET button of the right-
VOICE TRIGGER