User's Manual
10
The primary func-
tions are aileron, elevator, rudder and throttle (or airbrakes).
1. Enter the France mode in country setting after Insert the supplied shunt connector into the data
socket at the back of the transmitter.
2. Press MODE button once more, The Graupner/SJ logo blinks red with 3 times beeps, indicating
that the stick setting is in the stick mode 1 that is preset at the factory. Each time you press MODE
button, the beep is increased one at a time and the mode is changed in turns.
3. After selecting the desired the stick mode, press MODE button for over 2 sec, the Stick setting is
completed with a beep.
2 - 1. Move transmitter’s RF TRAINER SWITCH to NORMAL position. Bind the pupil transmitter to the
pupil receiver.
2 - 2. Set the transmitter to PUPIL mode, the connection would be lost between the transmitter and
receiver.
2 - 3. Set the another transmitter to TEACHER mode.
2 - 4. Press & hold the MODE button of the pupil transmitter until the
the MODE button of the teacher transmitter until the beep as well. Now the teacher transmitter
to pupil transmitter has been bound. The teacher transmitter can control all channels and
if RF TRAINER SWITCH of the teacher transmitter would be moved to PUPIL position, the
pupil transmitter can control all channels.
2) Trainer Operation
12. Stick setting
After completing the normal setting, Graupner/SJ logo turns solid red in the General mode
and blinks
red in the France mode.
Teacher setting: The Graupner/SJ logo repeats to blink twice red, 2 beeps sounds twice.
Pupil setting: The Graupner/SJ logo repeats to blink a single red, 1 beep sounds twice.
NOTICE
1-3. Normal setting
Getting back to the NORMAL mode from TEACHER or PUPIL mode, move transmitter’s RF TRAIN-
ER SWITCH to NORMAL position. Press & hold the MODE button and switch on the transmitter
then the transmitter enters the failsafe mode automatically. The Graupner/SJ logo repeats to blink
a single red with a single beep. Turn off the transmitter then the NORMAL setting is completed.
1-2. Pupil setting
off the transmitter, and still the receiver is turned on, and move transmitter’s RF TRAINER SWITCH
to PUPIL position. Press & hold the MODE button and switch on the transmitter. The Graupner/SJ
logo repeats to blink a single red with a single beep, indicating that you set PUPIL Mode. After one
beep sound twice, a beep doesn’t sound. Now the Teacher’s transmitter can bind and control all
channels of the mz-10 without restriction.