User's Manual

6
Assemble the transmitter’s rear case and switch to mode 2 from mode 1 at Stick mode page in
the transmitter programming setup section according to the manual.
5 9
7
6 10
8
Make sure to test all functions are normally operated in mode 2 before ying
NOTICE
Unscrew the tension spring control bolt in
the elevator gimbal of mode 1 transmitter
Assemble the centering cam into the
throttle gimbal of mode 1 transmitter and set
the spring in the center control part and the
centering cam with tweezers
Assemble 2pcs of disassembled leaf
spring from the throttle gimbal of mode 1
transmitter into the elevator gimbal and adjust
the bolt for the desired control
Screw the disassembled bolt from the
throttle gimbal of mode 1 transmitter into the
elevator gimbal to x the controller
Screw the disassembled tension con-
trol bolt from the elevator gimbal of mode
1 transmitter into the throttle gimbal and
adjust the bolt for the desired control
Assemble the disassembled centering
cam form the elevator gimbal of mode 1 trans
-
mitter into the throttle gimbal pin
Tension spring