User's Manual

8
The mz-10 offers a dual rare function on aileron, elevator and rudder. When the DUAL RATE
SWITCH is in the up position, 100% travel is achieved on the aileron, elevator and rudder chan-
nels. When the switch is in the down position a reduced travel of 70% is achieved on the aileron,
elevator and rudder channels. This is useful allowing the aircraft to have a high control rate (switch
in the up position) for aggressive maneuvers and a low control rate (switch in down position) for
smooth, precise maneuvers.
According to the LED status of each channel, you may check that the direction of servo rotation is in
the normal or reverse, LED blinking means that direction of servo rotation is in the normal and LED
turning on means that the direction of servo rotation is in the reverse.
1. Press & hold the DIRECTION button for over 2 sec and then release the button, the transmit-
ter enters reverse mode and the LED of No. 1 channel blinks.
2. Press the MODE button, the LED of No. 1 channel goes solid and the direction of servo rotation is
in the reverse.
3. Whenever you press the DIRECTION button, you may select the channel that you want and may
set the direction of servo rotation in the same method above.
4. After setting servo reversing function, press & hold the DIRECTION button for over 2 sec and then
release the button, now all servo reverse setting is stored to the transmitter.
5. Servo Reversing
6. Dual Rate
The mz-10 offers a delta wing mix. delta wing mixing combines the function of ailerons with the
function of the elevator to allow precise control of both roll and pitch for delta wing aircraft.
7. Delta Wing
1. Press & hold the DIRECTION button for over 2 sec and then release the button, the transmit-
ter enters Reverse mode.
2. Press the DIRECTION button repeatedly until the delta LED is on, then the transmitter enters
delta mode. If delta mode is not set previously, the LED would blink.
3. Press the MODE button, the LED goes solid and delta wing function is activated.
4. After setting delta wing function, press & hold the DIRECTION button for over 2 sec and then release
the button, the delta LED turns solid green, the delta wing setting is stored to the transmitter.
2 ailerons function is designed to allow more precise control. you may use 2 separate channels to
control the left and right aileron
If the model features a V-tail instead of a conventional tail, you need to set V-tail.
1. Press & hold the DIRECTION button for over 2 sec and then release the button to enter reverse mode.
2. Press the DIRECTION button repeatedly until the 2 aile LED is on, then the transmitter enters 2
aile mode. If 2 aile mode is not set previously, the LED would ash.
3. Press the MODE button, the LED goes solid and 2 aile function is activated.
4. After setting 2 aile function, press & hold the DIRECTION button for over 2 sec and then release the
button, 2 aile LED turns solid green and 2 aile setting is stored to the transmitter.
1. Press & hold the DIRECTION button for over 2 sec and then release the button, the transmit-
ter enters reverse mode.
2. After setting of delta and 2 aile according to above described procedure, press & hold the DIRECTION
button for over 2 sec and then release the button. Delta LED and 2 aile LED go solid green together
and V-tail function is activated. Delta LED and 2 aile LED are off after 5 seconds.
8. 2 AILE
9. V-Tail
100%
70%