User manual

Adam Hall GmbH · Daimlerstr. 9 · 61267 Neu-Anspach · Germany
Tel.: (+49) 60 81 / 94 19 0 · Fax: (+49) 60 81 / 94 19 1000 · eMail: [e-mail]
SAFETY INFORMATION
1. Please read these instructions carefully before you start installation and assembly.
2. Keep all information and instructions in a safe place.
3. Follow the instructions.
4. Observe all safety warnings. Never remove safety warnings or other information
from the equipment.
5. Be attentive when setting up the product and protect yourself from injury.
6. This product is intended for indoor use only. Using it outdoors could lead to
product failure and personal injury.
7. Do not modify this equipment.
8. Comply with all applicable disposal laws in your country. During disposal of
packaging, please separate plastic and paper/cardboard.
9. Plastic bags must be kept out of reach of children.
10. If you have any questions refering to this instruction or any warnings, please
contact your local distributor.
MANUFACTURER’S WARRANTY & LIMITATION OF LIABILITY
You can find our current warranty conditions and limitation of liability at: http://www.
adamhall.com/media/shop/downloads/documents/manufacturersdeclarations.
pdf
To request warranty service for a product, please contact Adam Hall GmbH,
Daimler Straße 9, 61267 Neu Anspach / Email [e-mail] /
49 (0) 6081 / 9419-0
PROPER DISPOSAL OF THIS PRODUCT
(WASTE ELECTRICAL AND ELECTRONIC EQUIPMENT)
(Valid in the European Union and other European countries with waste
separation)
This symbol on the product, or the documents accompanying the product, indicates
that this appliance may not be treated as household waste. This is to avoid environ
-
mental damage or personal injury due to uncontrolled waste disposal. Please dis-
pose of this product separately from other waste and have it recycled to promote
sustainable economic activity.
FEATURES
Microphone holder for table tops, podiums etc.
3/8“ threaded bolt
Plastic tipped set screw
Black powder coating nish
For up to 45 mm table top thickness
INTRODUCTION
The Gravity MSTM 1 B microphone table clamp rmly attaches to desk or podium tops
with a maximum thickness of 45 mm. It is made of 4 mm steel with a plastic tipped set
screw and 3/8“ threaded bolt for mic clip, mic clamp or gooseneck mounting.
SPECIFICATIONS
Product type: microphone holder
Colour: black
Surface: powder coated
Threaded connector: 3/8"
For table top thickness: up to 45 mm
Weight: 0.2 kg
GMSTM1B
Microphone Table Clamp