User's Manual

Product Reference Guide
© 2007 Grayhill, Inc. | Proprietary Content | All Rights Reserved
Aligning the Handheld Touch Screen
The Handheld’s touch screen may require initial calibration to align the touch screen cursor with the tip of
your stylus. To launch the calibration, tap
; then tap Settings; then tap Control Panel; then tap .
Click on the calibration tab, and then click on Recalibrate. To calibrate your screen, tap the
center of each alignment target with the tip of the stylus. Once the calibration is successful the screen will
prompt the user to press escape or tap the screen.
Resetting
By default, the Handheld’s instant-off feature causes it to go into immediate “low power” mode where closed
programs are still in memory, but the screen’s backlight is off. If the Handheld will not be used in the near
future, batteries should be removed.
Soft resets of the Handheld are accomplished by:
1) Selecting Restart, located in MyDevice>Windows>Restart.exe, or
2) Responding affirmatively to a request for restart from an installer or other program. When so instructed,
click Yes on the pop up box for restart.
To conduct a hard reset, hold the Power button down for 6-10 seconds, until the screen goes black.
This will clear the Handheld's RAM and reload the OS from Flash.
Figure 2
Recalibration Prompt Screen
Figure 3
Restart Prompt
6